Call (970) 259-8777

2011 GMC Sierra

//2011 GMC Sierra

2011 GMC Sierra

GMC Sierra

Mileage
199,474
Service Date
3/5/2021
Services Performed
  • INSTALLED NEW CAP
  • REPLACE AND PROGRAM THE STEERING ANGLE SENSOR
  • REPLACE THE #2 AND #7 GLOW PLUGS
  • REPLACE THE ENGINE OIL PRESSURE SWITCH
  • REPLACE THE STOP LIGHT SWITCH
  • This inspection and the opinions expressed are exactly that, opinions. Many parts perform perfectly until the moment of failure. Failure may occur suddenly and without warning. The inspector and/or all parties relative to the compilation of this report cannot accept liability for failures, which may occur after the inspection is completed. By accepting this report, the consumer acknowledges that the inspector and/or all parties relative to the compilation of this report, cannot be held responsible for any and all alleged vehicle defects, and further, the consumer releases and holds harmless the inspector and/or all parties relative to the compilation of this report from any and all further claims on this vehicle. No warranty for this vehicle is implied or given by the inspector and/or all parties relative to the compilation of this report.
  • UPON INSPECTION SCANNED THE VEHICLE FOR TROUBLE CODES, FOUND TROUBLE CODES C0710 Steering signal sensor signal circuit plausibility failure INSPECTED WIRING TO STEERING SENSOR, GOOD, TESTED FOR PROPER POWER AND GROUND, GOOD, PERFORMED ON DEMAND TESTING AND FOUND THAT THE SENSOR HAS SHORTED OUT INTERNALLY AND WILL NEED TO BE REPLACED AND PROGRAMMED, THEN RETEST THE SYSTEM. AFTER REPLACING THIS SENSOR WE CLEARED CODES AND TEST DROVE, THE CODE HAS NOT RETURNED.
  • UPON INSPECTION SCANNED THE VEHICLE FOR TROUBLE CODES, FOUND TROUBLE CODES P0522 Engine oil pressure sensor circuit low INSPECTED THE ENGINE OIL LEVEL, GOOD, INSPECTED AND PINPOINT TESTED WIRING TO THE ENGINE OIL PRESSURE SENOR, GOOD, PERFORMED ON DEMAND TESTING AND FOUND THAT THE ENGINE OIL PRESSURE SENSOR HAS FAILED INTERNALLY AND WILL NEED TO BE REPLACED AND THEN THE SYSTEM RETESTED. AFTER REPLACING THE SWITCH WE FOUND THE GAUGE TO READ PROPERLY WHEN TURNING ON KEY AND STARTING ENGINE.
  • UPON INSPECTION SCANNED THE VEHICLE FOR TROUBLE CODES, FOUND TROUBLE CODES, P0571 Brake switch circuit 1 (history code) P0672 Glow plug #2 control circuit P0677 Glow plug #7 control circuit PINPOINT TESTED THE WIRING TO THE STOPLIGHT SWITCH, SWITCH HAS GOOD POWER AND GROUND AT THIS TIME, PERFORMED ON DEMAND TESTING AND FOUND AT THIS TIME THE SWITCH IS WORKING OK, ADVISED THE CUSTOMER WE SUSPECT IT IS INTERMITTENTLY FAILING AND RECOMMEND REPLACEMENT FOR SAFETY, OHMED GLOW PLUGS AND FOUND GLOW PLUGS 2 AND 7 HAVE FAILED RECOMMEND REPLACEMENT AND THEN RETEST. AFTER REPLACING THE STOP LIGHT SWITCH, WE FOUND IT TO WORK FINE AND CODE DID NOT RETURN. AFTER REPLACING THE GLOW PLUGS, WE CLEARED CODES AND TEST DROVE AND THE CODES HAVE NOT RETURNED.
 
IVAN M. gave our service a 5 star review on 3/10/2021
2021-03-12T23:02:30+00:00